News

How do I prepare and position my sample for measurement with the 3D Contour Microscope?

Publish Time: 2024-05-25
To prepare and place samples for measurement with the 3D Contour Microscope, the following steps can be followed:

Sample Collection:

Choose a suitable collection method based on the object or structure to be observed. For example, for biological cells, samples can be collected by culturing cells; for solid materials, small pieces or thin slices can be cut from them as samples.

Sample Processing:

After collecting the sample, it needs to be processed to ensure that the sample can be clearly seen under the microscope.

Wash it with an appropriate solution or detergent, and then rinse it with pure water. For biological samples, physiological saline can be used for cleaning.

Make sure the microscope lens is clean and adjust the appropriate magnification.

Sample Placement:

Place the processed sample on the microscope slide.

For biological samples, it may be necessary to cover it with a coverslip to prevent the sample from moving or drying during observation.

Make sure the sample is completely flat and avoid bubbles or impurities. This helps to obtain more accurate 3D contour data.

Adjust the microscope:

Turn on the microscope and adjust the light source and contrast as needed.

Choose the appropriate magnification and lens to ensure that the contour of the sample is clearly visible.

Software Settings:

If you are using a software-controlled 3D Contour Microscope, you need to make the necessary settings in the software, such as scanning area, resolution, and measurement parameters.

Start the measurement:

Place the slide with the sample on the sample stage of the microscope.

Start the scanning program in the software and let the microscope automatically scan the contour of the sample.

After the scan is completed, the software will generate a 3D contour image and data of the sample.

Data Analysis and Recording:

Analyze the generated 3D contour image and data to obtain the required measurement results.

Record the measurement results and can perform further processing and analysis as needed.

Please note that the specific steps may vary depending on the different 3D Contour Microscope models and software. Therefore, before actual operation, it is recommended to read the manual of the microscope carefully and follow the instructions provided by the manufacturer.
×

Contact Us

captcha